Short answer: A shower pump only works if your flat has stored water: a hot water cylinder fed by a cold water tank. It boosts that stored supply. If your top floor flat runs on a combi boiler or mains pressure, a pump is not suitable, and the fix is usually a better supply pipe, a different shower or stored hot water.
Weak showers are one of the most common complaints from top floor flats in Glasgow. In a four storey tenement in Shawlands or Battlefield, the top flat is a long way from where the supply enters the building, and the plumbing may have been altered several times over a century. A shower pump sounds like the obvious answer. Sometimes it is. Often it is not.
Step one: find out how your water is fed
Everything depends on this.
| What you have | What it means | Does a pump suit? |
|---|---|---|
| Combi boiler, no cylinder | Hot and cold come straight from the mains | No |
| Cylinder plus a cold tank above it or in the roof space | Vented, tank fed hot water | Yes, often |
| Cylinder at mains pressure with an expansion vessel, no tank | Unvented system | No, it is already mains pressure |
| Electric shower only | Fed from the cold mains | No |
Open the press cupboard where the boiler or cylinder lives. A copper cylinder with a small plastic or galvanised tank above it, or a pipe going up to the roof space, tells you it is tank fed. A combi boiler on the kitchen wall with nothing else means mains fed.
Why pumps only work on stored water
A shower pump pushes water that is already stored at low pressure in your tank and cylinder. On a tank fed system, the pressure at the shower depends on how high the tank sits above the shower head. In a top floor flat with the tank only a short way above the bathroom, that pressure can be very low. A pump fixes that.
On a mains fed system, a pump would be pulling straight from the supply pipe. That can starve neighbours on the same rising pipe, and Scottish Water’s byelaws restrict pumps that draw directly from the mains. So a pump is not the answer on a combi.
If you are tank fed: making a pump work well
A pump on a tank fed system can give a strong shower, but a few things decide whether it works well:
- Tank size. A small tank can run dry with a powerful pump. The cold tank has to refill from the mains while you shower.
- Cylinder size. A pump uses hot water faster, so a small cylinder runs cold sooner.
- The right type of pump. Positive head pumps suit tanks well above the shower. Negative head pumps are for showers at or above the level of the tank, which is common in top floor flats. Fitting the wrong one causes problems.
- Pipework. A dedicated feed from the cylinder, sometimes with a special flange fitting, stops the pump pulling air.
- Noise. In a tenement, a pump on a timber floor can carry noise to the flat below. Mounting it on anti vibration feet and in the right spot helps.
If you are mains fed: what actually helps
Most top floor flats with a combi boiler have weak showers because the combi cannot get enough cold water flow, not because the boiler is weak. A combi heats what it is given.
The usual causes are:
- an old narrow supply pipe up through the close, sometimes lead or iron
- a partly closed or worn stop tap
- a long run from the stop tap to the boiler
- a shower valve or head that restricts flow
We measure the flow at the kitchen tap and at the boiler. If the flow is poor, renewing the supply pipe from the stop tap to the flat, or replacing a lead section, often makes the biggest difference. Scottish Water says homes built before 1970 have a higher chance of lead pipework, and the owner is responsible for the supply pipe from the boundary stop cock into the property, as set out on its lead pipes page. In a tenement, a rising pipe that serves several flats is common property of the flats it serves, so renewing it may need neighbours’ agreement.
If the problem is low pressure on the street, which you would notice in every flat, Scottish Water is the right first call on 0800 0778 778. Our guide to low water pressure in Glasgow goes through how to tell.
Other options
Electric shower. It heats cold mains water as it goes. It needs reasonable mains pressure and a dedicated electrical circuit fitted by a qualified electrician. Scotland has no Part P, but the work must meet the building standards and the wiring regulations.
Unvented cylinder. It stores hot water at mains pressure. It needs good incoming flow and space in a cupboard, and it must be installed by someone with appropriate training under standard 4.9 of the Scottish domestic technical handbook. It suits bigger flats better than small ones.
A low flow shower head. It will not add pressure, but some heads feel stronger at low flow. Cheap to try.
Soft water helps here
Glasgow’s water is soft. Scottish Water’s 2024 hardness data puts the Milngavie zones that supply most of the city at about 16 mg/l as calcium carbonate. Shower heads and pump impellers rarely clog with scale here, so if a shower gets weaker over time, look at the supply, a strainer or the valve rather than limescale.
What we do
We check how your flat is fed, measure the flow and pressure, and look at the tank, cylinder and supply pipe. Then we recommend the option that will work, which is not always the pump you asked about. If you are on the Southside, our Southside page explains more about the tenements we work in, and our bathroom and shower page covers full refits.
Quick questions
Can I fit a shower pump to a combi boiler?
No. Shower pumps are made for stored water. Scottish Water's byelaws restrict pumps drawing straight from the mains supply, and a combi runs on mains water.
How do I know if I have a tank fed system?
Look for a hot water cylinder in a cupboard with a small cold water tank above it or in the roof space. If you have a combi boiler and no cylinder, you are mains fed.
Why is my top floor flat weaker than the ground floor?
Water has to climb further, and in older tenements the supply pipe up the building can be narrow or partly furred with corrosion. Some top flats are fed from a tank with very little height above the shower.
Is an electric shower a good option?
It can be, if the cold mains pressure is reasonable and your electrics can carry a dedicated circuit fitted by a qualified electrician.
Last updated 23 October 2026. Written for homes in Glasgow. Rules can change, so check the linked sources for the latest position.